Lane Changer Installation Instructions

You do not need to be Technical to install these products Tools Reqd. Screwdriver, pliers/cutters  Difficulty rating scale 2 out of 10

   I. Description

By simply touching your indicator switch up or down Once, Blinking Smart Lane Changer will flash your indicator lights an additional 6 times.

Plus Version Only:

For use on automobiles that only have a single dashboard turn signal indicator light, the Plus version provides an Activity Output used to flash an alternate light to show when the One Touch Lane Changer has been activated.

   II. Features

• Size: 2" x 2" x 0.75" (51mm x 51mm x 19mm)

• Operating Voltage: 12 Volts DC

• Operating Temp: -30ºC to +70ºC

• Max Power Consumption: 1.6W

   III. Circuit Diagram

   IV. Installation Instructions

Note:  DO NOT cut existing wires.

1. Locate access to the left and right turn indicator wires. The easiest way to access them is from where you change the existing bulbs.

2. Locate where you have access to a 12 volt power source. If you plan to connect to a switched 12 volts, this can be done at any 12 volt connection controlled by the ignition switch, such as the one that goes to the radio or cigarette lighter.

3. Place a “Quick Connect” connector over left indicator circuit and insert one Blue wire. Using the pliers, squeeze the metal splice to secure the wires and then snap the cover closed.

4. Place a “Quick Connect” connector over right indicator circuit and insert second Blue wire.  Using the pliers, squeeze the metal splice to secure the wires and then snap the cover closed.

5. Attach the Black wire to ANY chassis ground connection. Use a “Quick Connect” connector to attach to an existing ground wire.

6. Place a “Quick Connect” connector over 12 Volt connection and insert Red wire. Squeeze and snap as in steps 3 and 4.

Plus Version Only:

7. Select an available alternate in-dash light or mount an external add-on light that will be used to
   show when the One Touch Lane Changer has been activated.

8. Connect Brown wire to the plus (+) side of this alternate light and then make sure that the minus (-) side has been connected to ground. 

Click here to view the Standard Version in pdf form.

Click here to view the Plus Version in pdf form.

Give yourself a chance, avoid becoming a victim and a statistic.

Copyright © 2006,  Kahtec Technologies International.  All rights reserved.  l  Privacy Policy - Site Map

For auto safety accessories, Lighting and other Laws vary from state to state and country to country.  Kahtec Technologies Int. makes no representation or warranty to the legality of its products for street use on any vehicle or in any location.